Publicité
Les langues disponibles
Les langues disponibles
Recording adjustments and other operations are performed
from the recording component. Refer to the instructions for
these components.
D I G I T A L
SURROUND
STANDBY
/ON
BASS
TREBLE
BALANCE
SPEAKERS
A
B
PROGRAM
–
+
–
+
ON
OFF
L
R
PHONES
S VIDEO
SILENT
(RX-V520)
2
1
Set the volume at the
minimum level.
2
Select the source you want to record.
INPUT
Front panel
3
Begin recording by the recording component
connected to this unit.
4
Play the source and then turn up the volume to
confirm the input source.
VOLUME
Front panel
RECORDING A SOURCE
VOLUME
D I G I T A L
INPUT MODE
PRESET
/TUNING
FM/AM
INPUT
EFFECT
PRESET/TUNING
A/B/C/D/E
EDIT
TUNING
MEMORY
MODE
MAN'L/AUTO FM AUTO/MAN'L MONO
VIDEO
L AUDIO R
OPTICAL
VIDEO AUX
2
4
VOLUME
Front panel
or
Remote control
or
Remote control
Notes
• Do a test recording before you start an actual recording.
• When this unit is set in the standby mode, you cannot record
1,4
between other components connected to this unit.
• The DSP program and the setting of VOLUME, BASS, TREBLE
and BALANCE have no effect on the material being recorded.
• A source connected to the 6CH INPUT jacks of this unit cannot
be recorded.
• A given input source is not output on the same REC OUT
6CH INPUT
channel. (For example, the signal input from VCR 1 IN is not
output on VCR 1 OUT.)
• Check the copyright laws in your country to record from records,
CDs, radio, etc. Recording of copyrighted material may infringe
copyright laws.
RX-V520 only
•
Composite video and S video signals pass independently through
this unit's video circuits. Therefore, when recording or dubbing
video signals, if your video source component is connected to
provide only an S video (or only a composite video) signal, you
can record only and an S video (or only a composite video) signal
by your VCR.
If you play back a video source that uses scrambled or
encoded signals to prevent it from being dubbed, the
picture itself may be disturbed due to those signals.
I Special considerations when
recording DTS software
RX-V520 only
The DTS signal is a digital bitstream. Attempting to
digitally record the DTS bitstream will result in noise being
recorded. Therefore, if you want to use this unit to record
sources that have DTS signals recorded on them, the
following considerations and adjustments need to be made.
For DVDs and CDs encoded with DTS
Only 2-channel analog audio signals may be recorded.
Set the DVD player (or CD player) as described in the
player's operation instructions so that the audio signals are
output from the player's analog outputs.
31
Publicité
