Publicité
Les langues disponibles
Les langues disponibles
SET MENU
I BASS OUT (bass out mode)
LFE signals carry low-frequency effects when this unit
decodes a Dolby Digital or DTS signal. Low-frequency
signals are defined as 90 Hz and below.
Choices: SWFR (subwoofer), MAIN, BOTH
Initial setting: BOTH
SWFR
Select this if you use a subwoofer. The LFE signals are
directed to the subwoofer.
MAIN
Select this if you do not use a subwoofer. The LFE signals
are directed to the main speakers.
BOTH
Select this if you use a subwoofer and you want to mix the
main channel low-frequency signals with the LFE signals.
Notes
• When playing a 2-channel source (CD, MD, tape, video cassette
etc.), select BOTH position to direct low bass signals (below
90 Hz) to the SUBWOOFER jack.
• When you select SMALL (SML) for items "CENTER SP",
"MAIN SP" and "REAR LR SP", the low-frequency signals
(90 Hz and below) from those channels are added to the LFE and
output to the subwoofer.
I MAIN LVL (main level mode)
Change this setting if you cannot match the output level of
the center and rear speakers with the main speakers because
of the unusually high-efficiency performance of the main
speakers.
Choices: NORM (normal), –10 dB
Initial setting: NORM
NORM (normal)
Normally select this setting.
–10 dB
Select this if you cannot match the output level of your
effect speakers with that of your main speakers when using
the test tone. This setting decreases the main speaker output
level to about one-third of the normal level.
34
2 HP TONE CTRL (headphone tone
control)
Use this feature to adjust the level of the bass and treble
when you use your headphones.
Control range (dB): –6 to +3
Initial setting: 0 dB for both BASS and TRBL (treble)
3 I/O ASSIGN
It is possible to assign jacks according to the component to
be used if this unit's DIGITAL jack settings (component
names for terminals) differ from that component. This
makes it possible to change the jack assignment and
effectively connect more component.
Once you assign, you can select that component with
INPUT l / h (or the input selector buttons).
RX-V520
I 3A (1) (for the OPTICAL OUTPUT
jack)
Initial setting: (1) MD/CD-R
I 3B (2) to (4) (for the OPTICAL
INPUT jacks)
Initial settings: (2) MD/CD-R
(3) DVD
(4) D-TV/CBL
dB
dB
Publicité
