Publicité
Les langues disponibles
Les langues disponibles
6
Lighting Instructions
WARNING!
WARNING!
2. Push and turn any main burner knob slowly
to the 'hi' position. This action will ignite the
pilot flame which will in turn light the selected
burner. If the pilot lights, continue to push
down on the control knob until the burner
3. If the pilot does not ignite, then
immediately turn the control knob back to the
'off position and repeat step 1 several times.
4. If the pilot and burner will not ignite within
5 seconds, turn the control knob to the 'off'
position and wait 5 minutes for any excess gas
to dissipate. Either repeat steps 1 and 2 or
WARNING!
WARNING!
WARNING!
www.napoleongrills.com
Rear Burner
Lights Left Burner
Open lid
Ensure all burner controls are in the off position. Turn on the gas supply valve.
Main Tube Burner
Lighting
1. Open grill lid.
lights and then release.
.
light with a match.
The propane cylinder is equipped with an excess flow device. Unless all burners are turned off
prior to turning the cylinder on, only small flames and low heat will be achievable.
Do not use the rear burner (rotisserie burner) with the main burners operating.
If lighting the unit with a match, clip the match into the supplied lighting rod.
Hold the lit match down through the grill and sear plate while turning the cor-
responding burner valve to high.
Centre Burner
Right Burner
Rear Burner Lighting
(Rotisserie Burner)
1. Open grill lid.
2. Remove the warming rack
3. Push and turn the rotisserie burner
control knob slowly to the 'hi' position. This
action will ignite the pilot flame which will
in turn light the burner. If the pilot lights,
continue to push down on the burner
control knob until the burner lights then
release.
4. If the burner does not ignite, then
immediately turn the control knob back to
the 'off' position and repeat step 2 several
times.
5. If the burner will not ignite within 5
seconds, turn the control knob to the 'off'
position
And wait 5 minutes for any excess gas to
dissipate. Either repeat steps 2 and 3 or
light with a match.
Side Burner
Side Burner Igniter
Off Position
Side Burner Lighting
(If equipped)
1. Open side burner cover.
2. Push and turn side burner control to
high position.
3. Press and hold
igniter button until burner lights, or light
by match
4. If the burner will not ignite within 5
seconds, turn the control knob to the
'off' position and wait 5 minutes for any
excess gas to dissipate. Either repeat
steps 2 and 3 or light with a match.
Publicité
