Publicité
Les langues disponibles
Les langues disponibles
venting requirements
EN
2.11
rear exit shield (for rear vent only)
A.
Remove the safety barrier assembly and door from the appliance (see "safety barrier & door
removal / installation" section).
B.
Loosen the two screws that secure the exhaust plate, and slide the shield in place by sliding its
slotted openings behind the screwheads. Tighten the two previously loosened screws (Fig. 1).
C.
Reinstall the door and safety barrier assembly on the appliance (see "safety barrier & door
removal / installation" section).
note:
This shield is used to block the view through the venting to the outdoors.
24
W415-1847 / A / 03.11.19
Fig. 1
Publicité
