Napoleon Ascent 36 Serie Manuel D'installation Et D'utilisation page 25

2.12 top exit
WARNING
!
• Failure to install the cover plate and gasket will cause the appliance to function improperly and can cause
injury or property damage.
A.
Remove the safety barrier and glass door (see "safety barrier & door removal/installation" section).
B.
Remove the contents from the fi rebox and set aside.
You will need the exhaust and air inlet collar.
C.
To ease assembly, remove the 4 hex head screws,
securing the defl ector from inside the top front of the
fi rebox (Fig. 1).
D.
Remove the outer cover plate and gasket by removing the 4 screws. Install the outer cover plate and
gasket onto the back of the appliance using the 4 previously removed screws (Fig. 2).
E.
Remove the 1 1/2" (38.1mm) thick batt of insulation and discard (Fig. 2).
F.
Remove the 4 screws securing the inner cover plate and gasket. Remove the inner cover plate and discard
(Fig. 2).
G.
Place the 7" (177.8mm) intake collar and gasket onto the top of the appliance and secure using 4 screws.
tip:
The screws are packaged in a separate baggie from the manual baggie.
H.
From inside the fi rebox, install the 4" (101.6mm) exhaust collar with gasket up through the top of the
fi rebox, and secure with the the 4 hex head 3/4" black screws supplied in the manual baggie (Fig. 3).
note:
Do not overtighten. The gasket needs only to be snug against the fi rebox.
I.
Reinstall the defl ector, glass door, and safety barrier.
OUTER
COVERPLATE
GASKET
INNER
COVERPLATE
GASKET
1 1/2" INSULATION BATT
OUTER
COVERPLATE
GASKET
Fig. 2
venting requirements
DEFLECTOR
W415-1847 / A / 03.11.19
EN
Fig. 1
EXHAUST
FLUE COLLAR
FIG. 3
Fig. 3
25