SLIDE WIRE
INTO GUN
CONNECTOR
SIDE
REMOVED NOZZLE
REMOVED CONTACT TIP
LAY CABLE AND GUN STRAIGHTEN
IN THIS POSITION
FEED WIRE
APPROXIMATELY 4.00"
FROM THE GUN TUBE END
DEPRESS TRIGGER
TO ACTIVATE WIRE,
WHICH FEEDS THE WIRE
THRU THE LINER.
TRIM WIRE
STICKOUT
3/8"(9.5mm)
from the Nickel Nozzle
PIVOT ARM ASSEMBL Y
WITH BEARING PRESSING AGAINST DRIVE ROLL
TENSION ARM ASSEMBL Y
LOCKED IN UP POSITION
BEARING
INCOMING
GUIDE
DRIVE ROLL
OUTGOING GUIDE
ON/OFF
SWITCH
WIRE SPOOL BRAKE
WORK CLAMP AND CABLE
INSTALL .025(0.6mm) CONTACT TIP
INSTALL NICKEL NOZZLE
DIRECTION
OF WIRE
WIRE SPOOL
.025" (0.6mm)
L-56 Solid
MIG WIRE
WIRE SPOOL
.025" (0.6mm)
PLUG IN POWER
INPUT CORD
WIRE SPOOL
.025" (0.6mm)
ROTATION