Zanussi ZDV 14001 Notice D'utilisation page 24

3
To remove filters (B)
and (C), turn the han-
dle counterclockwise
and remove. Pull
apart filter (B) and
(C). Wash the filters
with water.
D
A
5
Put filter (A) to its ini-
tial position. Make
sure that it assembles
correctly under the
two guides (D).
Troubleshooting
The appliance does not start or it stops during
operation.
First try to find a solution to the problem (refer
to the table). If not, contact the Service.
Alarm code
• The indicator of the set programme flashes contin-
uously.
• The end indicator flashes 1 time intermittently.
• The indicator of the set programme flashes contin-
uously.
• The end indicator flashes 2 times intermittently.
24
A
4
Remove filter (A).
Wash the filter with
water.
6
Assemble filters (B)
and (C). Put them in-
to position in filter
(A). Turn the handle
clockwise until it
locks.
An incorrect position of the filters can
cause bad washing results and damage to
the appliance.
Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clogged, re-
move remaining parts of soil with a thin pointed
object.
External cleaning
Clean the appliance with a moist soft cloth.
Only use neutral detergents. Do not use abra-
sive products, abrasive cleaning pads or sol-
vents.
With some problems, some indicators
flash continuously and/or intermittently
at the same time to show an alarm code.
Problem
The appliance does not fill with water.
The appliance does not drain the water.
www.zanussi.com