Aiwa MIZUSUI AFC-800 Manuel D'instructions page 17

Installation: Position the roller brush onto the right axle and press it down. The roller
brush unlock button has a buckle for positioning. Assembly is complete when you
hear a "click," as shown in Figure 4-Q.
Note: The roller brush is pre-installed when the product leaves the factory. This
procedure is for daily storage and maintenance.
Removal and Installation of Side Brush Assembly
Disassembly: Rotate the side brush clockwise according to the marked direction to
unlock it, and then pull it outward, as shown in Figure 4-R.
Installation: Insert the side brush into the corresponding slot of the roller brush.
Rotate it counterclockwise in the marked direction to lock it in place, as shown in
Figure 4-S.
Product Charging
1. Insert the adapter into the base charging port and the power plug board as shown
in Figure 4-P.
2. Place the entire machine into the base assembly, as shown in Figure 4-Q. The panel
power display light will flash, indicating that the machine is in charging mode.
3. Once charging is complete, the panel power display will show "100" in white and
remain illuminated. Turn off the power switch and unplug the adapter.
Note: It is recommended to charge the product before its initial use.
DAILY MAINTANANCE
• Roller cleaning. Manual Roller Cleaning.
After every 4-5 floor sweeps, it is recommended to perform a thorough cleaning of the
rollers. To do this, use the hair processor at the end of the "multi-cleaning tool" handle
to remove hair from the rollers, as shown in Figure 5-A. Gently pull out the hair
processor, then press the handle button gently to let it snap back into place.
Note: To maintain long-term cleaning efficiency, place the used roller brush in a well-
ventilated area to dry, which helps extend its lifespan.
• Daily cleaning of the base
Please disconnect the adapter from the power supply. The concave surface of the
base can be rinsed with clean water. Ensure it is kept clean and recommended to dry
before use, as shown in Figure 5‐B.
• Daily Cleaning of the Brush Cover
The upper cover of the floor brush can be removed and rinsed with clean water to
keep it clean, as shown in Figure 5-C.
ENGLISH