Aiwa MIZUSUI AFC-800 Manuel D'instructions page 16

Assembly of fuselage and accessories
Insert the end of the hose assembly into the corresponding position on the main body
in the vertical direction shown in Figure 4-A. With a snap positioning mechanism, lift
it lightly, and complete the assembly when you hear a "click." To disassemble, press
the "release button." See Figure 4-B.
Insert the window brush, electric brush, and flat suction end into the corresponding
position on the head of the hose assembly according to the vertical direction shown in
Figure 4-B. With a snap positioning mechanism, complete the assembly when you
hear the "click." To disassemble, simply press the "release button." See Figure 4-B.
Start Working
Boot Operation: Tilt the main body by holding the handle, press the "power switch"
button, and start the roller brush. See Figure 4-G.
Water Spray Cleaning: Turn on or off the water spray function according to your
actual cleaning needs. When the system is on, you can choose to tap the "Low Water
Flow" or "High Water Flow" button on the handle and tap again to turn it off. See
Figure 4-H.
Shutdown Operation: To stop working, press the "power switch" button to turn off all
functions and return the machine to an upright position.
Roller Self-Cleaning
After finishing the floor cleaning, place the machine on the base, connect the
machine's adapter to the power source, and gently press the "
roller self-cleaning function. The cleaning duration is 30 seconds. Once the cleaning is
complete, it will automatically stop, and the machine will continue charging, as
shown in Figure 4-I.
Note: Since the roller will be wet after cleaning, it is recommended to place it in a
well-ventilated area to dry, so as not to affect the cleaning performance during the
next use.
Sewage Tank Cleaning
Step 1: Press the sewage tank release button and remove the sewage tank from the
machine, as shown in Figure 4-J.
Step 2: Lift and remove the waste water tank, as shown in Figure 4-K.
Step 3: Empty the sewage, as shown in Figure 4-L.
Step 4: Rinse the waste water tank with clean water, as shown in Figure 4-M.
Removal and Installation of Roller Components
Disassembly: Pull the roller unlock button to the left and lift up to remove the roller
brush, as shown in Figure 4-P.
ENGLISH
" button to start the