Publicité
Les langues disponibles
Les langues disponibles
4.
The danger LED lights
up on the display (Fig.
24.A) and the machine
emits a sound signal
5.
The danger LED lights up
on the display (Fig.24.A).
6.
The cut grass is no
longer collected in
the grass catcher.
7.
Mowing is difficult.
8.
Excessive noise and/
or vibration is experi-
enced whilst working.
9.
Battery power re-
serve is low.
10. The battery charger is
not charging the battery.
Cutting means blocked.
Machine fault.
Drive motor over current for heavy
working conditions (drive under stress).
The thermal protection has tripped
due to overheating of the machine.
The cutting means hit a foreign object.
The inner part of the chassis is soiled.
The cutting means is not in good state.
Cutting means fittings are loose or
the cutting means is damaged.
Severe working conditions requiring
greater current absorption.
Battery is insufficient for
operating requirements.
Battery is not correctly inserted
in the battery charger.
Unsuitable environmental conditions.
Dirty contacts.
The battery charger is not energised.
Faulty battery charger.
Turn the machine off, remove the
safety key and wear work gloves.
Check and eventually remove any obstructions
in the machine lower side (par. 7.3.2) that
prevent rotation of the cutting means.
If the problem continues, contact the
Authorised Service Centre for checks,
replacements or repairs (par. 8.1).
Remove the safety key and contact
the Authorised Service Centre for
checks, replacements or repairs.
– Make sure that the wheels are not
blocked. Clean as needed.
– Check the slope of the land you
are working on (par. 6.4.1).
Wait for at least 5 minutes and restart the
machine.
Immediately turn off the motor
and remove the safety key.
Check if there is any damage and
contact a Service centre to replace the
cutting means if necessary (par. 8.1).
Clean the inner part of the chassis to
facilitate the evacuation of the grass
toward the grass catcher (par. 7.3.2).
Contact the Authorised Service
Centre for the sharpening or
replacement of the cutting means.
Immediately turn off the motor
and remove the safety key.
Contact the Authorised Service Centre for
checks, replacements or repairs (par. 8.1).
Optimise operations (par. 7.2.1).
Use additional batteries or batteries with
extended power reserve (par. 15.2).
Check it is correctly inserted (par. 7.2.3).
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual).
Clean the contacts.
Check it is plugged in and the
power socket is energised.
Replace with an original spare part.
If the problem persists, refer to the
battery/battery charger manual.
EN - 13
Publicité
