Innotek Command Série Guide D'emploi page 7

english(eng).qxp 10/27/2005
Setting Stimulation Type, Level, and Tone
Your Command Series 1600E allows the transmitter to
operate two receiver collars. Each of these receivers
may have different stimulation type, level, and tone
from the other receiver collar.
Program your transmitter in just 4 button pushes.
A.
Press the round
BLUE button to
begin program-
ming
Setting Up the Collar Receiver
Install the battery. With the edge of the supplied wrench or a small coin, unscrew the battery
screw cap. Insert the supplied 3-volt lithium battery with the positive terminal (+) facing out.
Replace and tighten the battery screw cap.
Matching the Transmitter to the Collar Receiver
CAUTION:
Never place the collar on your dog before matching the collar receiver to the transmitter.
1. Hold the red paper dots on the transmitter and collar receiver together.
2. Continue to hold the red paper dots together during the following series of lights on the col-
lar receiver. A solid light will come on and go out followed by another solid light.
3. Separate the transmitter and collar receiver by about 30 cm. A flashing light will be on the
collar receiver.
4. Press Button 1 on the transmitter for 2 seconds. The light on the collar receiver will pulsate
red. Stimulation will be delivered when Button 1 is pressed so do not touch the probes.
5. Release Button 1. The light on the collar receiver will begin blinking green.
Note: We suggest you synchronize the yellow collar to the yellow column of buttons, blue col-
lar to the blue column, etc.
11:39 AM Page ENG-7
B. C.
Set stimulation Set stimulation
type by pressing level following
either the: the table on the
GREEN button previous page;
(Continuous in the DOG 1 col-
stimulation); umn, press
YELLOW either 1, 2, 3,
(momentary or 4.
stimulation) or 1. Lowest range
RED 2. Medium
(rising stimula- range
tion) 3. Med./High
range
4. Highest range
ENG-7
1
2
3
4
Fig. 3 – Programming the transmitter
D. E.
Set tone by Programming is
pressing either complete.
the: Repeat the pro-
GREEN button cedure for the
(tone with stimu- right-hand DOG
lation); 2 column.
YELLOW
(no tone with
stimulation) or
RED
(tone with 1.5
second delay
before stimula-
tion)