Publicité
Les langues disponibles
Les langues disponibles
english(eng).qxp
10/27/2005
Components
Before you begin, please take a few moments to become familiar with the basic components
and their functions.
Transmitter
Collar(s)
Probe Sets
Test light
Antennas
11:39 AM
Page ENG-2
Transmitter - The compact hand-held transmitter sends a coded signal
to the collar receiver and confirms operation whenever the button is
pressed. It operates on a 9-volt alkaline battery.
Training Collar - This rugged, water-resistant collar receiver is attached
to a strap. The dog receives the stimulus from the transmitter via the col-
lar receiver's probes.
Collar Probes - Two sets are included so you can use the collar with
dogs of varying coat thickness.
Test Light - To test the system, bridge the collar probes with the tester
and press the transmitter button. If the lamp glows, the collar is deliver-
ing stimulation.
Antennas - Two antennas are included. For best results, use the 5cm
antenna in European countries. The 17cm antenna may be used in the
USA only.
Batteries – Batteries are supplied for the transmitter and receiver col-
lar(s)
Lanyard – A nylon cord with clip is included. Clip the transmitter to the
lanyard; loop the lanyard around your wrist or neck to keep the transmit-
ter close at hand.
Probe wrench – A thin metal probe wrench is included for tightening
collar probes.
CS-300E
CS-1600TTE
•
1 – Trainer plus
3
•
•
2
ENG-2
CS-1600YE
•
•
1
Beeper
•
•
•
•
2
2
Publicité
