Télécharger Imprimer la page

Makita DG002GZ Manuel D'instructions page 10

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 12
Electronic function
The tool is equipped with the following electronic func-
tions for easy operation.
Electric brake
This tool is equipped with an electric brake. If the tool
consistently fails to quickly cease to function after the
switch trigger is released, have the tool serviced at a
Makita service center.
Soft start feature
This function allows the smooth start-up of the tool by
limiting the start-up torque.
ASSEMBLY
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery car-
tridge firmly when installing or removing battery
cartridge. Failure to hold the tool and the battery
cartridge firmly may cause them to slip off your hands
and result in damage to the tool and battery cartridge
and a personal injury.
► Fig.12: 1. Red indicator 2. Button 3. Battery
cartridge
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator as
shown in the figure, it is not locked completely.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
Mounting auger bit
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
When attaching the auger bit to the
spindle, make sure that the auger pin is locked
and inspect the auger pin for any damages.
CAUTION:
When carrying the tool, remove
the auger bit from the tool.
Mounting auger bit on spindle
NOTE: The shape and mechanism of the auger bit
and the auger pin may vary depending on your auger
bit.
Align the hole on the spindle with the hole on the auger
bit.
Put the auger bit onto the spindle.
► Fig.13: 1. Auger bit 2. Spindle
Fix the auger bit with the auger pin and the safety lock.
► Fig.14: 1. Auger pin 2. Safety lock
OPERATION
CAUTION:
This is a powerful tool which gen-
erates high torque. It is important that the tool is
securely held and properly braced.
CAUTION:
Before operating, check that there
is no foreign matter (sand, dirt, etc.) stuck in the
openings or moving parts.
Work posture
Maintaining proper operating position is one of the
most important and effective procedures for controlling
kickback.
Keep proper positioning by practicing the following
points.
Position the tool so that the bar of the reaction
receiver always contacts on the left side of your
waist.
Grasp the handle and the side handle with both
hands. Wrap your fingers around the gripping
areas, keeping the gripping areas cradled
between your thumbs and forefingers.
Keep your back as vertical as possible by bending
the legs as required during the digging process.
Stay alert to the torque reaction force of the tool.
Always keep the operating position that you can
withstand the torque reaction force.
► Fig.15: 1. Handle 2. Side handle 3. Bar of the reac-
tion receiver
WARNING:
not stand too far from the tool. Proper reaction and
control may not be achieved in the event of kickback.
► Fig.16
10 ENGLISH
Avoid improper positioning. Do

Publicité

loading

Ce manuel est également adapté pour:

Dg002g