ETNA A395 Notice D'utilisation page 19

2 phase connection
2 positive+2 negative 2 2N a.c. 230 V
The fuse box in your home must be fitted with
a 16 A fuse.
blue black next to blue
brown black next to brown
yellow/green
N1 N2 L1 L2
230V
230V
– negative connection N1 (blue)
– negative connection N2 (brown)
– positive connections L1 (black next to blue)
– positive connections L2 (black next to brown)
2 phase connection
2 positive+1 negative 2N a.c. 400 V
The fuse box in your home must be fitted with
a 16 A fuse.
blue yellow/green
brown black
black
N L1 L2
230V
230V
N.B. Don't use 3rd phase.
– negative connection N (blue and brown)
– positive connections L1 (black)
– positive connections L2 (black)
The following divergent connections are also
possible:
1 phase connection
1 positive + 1 negative 1N a.c. 230 V
The fuse box in your home must be fitted with
a 32 A fuse.
blue black
brown black
yellow/green
N L
230V
– negative connection N (blue and brown)
– positive connection L (black and black)
3 phase connection
3 positive without negative 3 a.c. 230 V
The fuse box in your home must be fitted with
a 16 A fuse.
blue black
brown black
yellow/green
L3 L2 L1
230V 230V
230V
– positive connections L1 (black)
– positive connections L2 (black)
– positive connections L3 (blue and brown)
Building in
1. Check if the kitchen cabinet and the cut out
are in accordance with the instructions
(see 'safety' and 'building in dimensions').
A
Fig. 15: Sealing strip
2. Remove the protective foil from the sealing
strip (A) and apply the strip as far out as
possible on the underside of the glass (see
fig. 15).
3. If the woodtop is made of treated wood,
then coat the sawn surfaces of the top with
sealing varnish, to prevent moisture
causing the top to swell.
4. Turn the appliance over and put it in the
cutout.
5. Connect the appliance to the electricity
supply.
6. Check its operation.
7. Hand over the instructions to your
customer.
NB: Immediately after switching on the fan
will start. The appliance will now carry
out a self-check for a few seconds.
Technical data
The model number, power supply and
connected load are specified on the data
plate.
The model number plate is attached to the
base of the appliance.
The connection cable is of the type Y.
The connection cable may only be replaced by
the manufacturer, the service organisation or
by similarly qualified persons.
This appliance complies with the CE directives.
Disposal of packaging and
appliances
The packaging of the appliance is recyclable.
It is made up off:
cardboard
polyethylene
CFC free polystyrene (PS rigid foam)
Please dispose of these materials in a
responsible way in accordance with the
regulations of your local authority.
Your local authority will also be able to give
you information about disposing disused
household appliances in a responsible way.