Publicité
Les langues disponibles
Les langues disponibles
Faults
Please check the following points which may solve the problem, before calling the service
department.
Sympton
Cause
The appliance does not work.
No power supply.
The lights do not light up.
The cooking zones are not
Ambient temperature too low
working, the message F0
(5 °C) before the hob was
appears.
plugged in.
The fan switches itself on.
The appliance checks itself
after the loss of power.
The appliance stops suddenly.
Ventilator is not far enough
open.
The message F7 appears.
Transistors overheated.
The lamps continue to flash
An unsuitable utensil is being
after switching on.
used.
Poor electrical connection.
Appliance is locked.
Keep on/off button (E)
depressed for 3 seconds.
Fault codes F00 – F08 in the
A control is defective, dirty or
display.
has an object lying on it.
Action
Check the electrical installation
(fuse(s), connection).
After installation, wait about ten
minutes. The messages stop
flashing and you can then use
the appliance.
The fan switches itself off.
Check ventilator openings at
front and back.
Press any button. The message
disappears. Restart at a lower
setting.
Use a suitable utensil.
Check if the cable is being
caught by the drawer. If it is,
have it changed by the installer.
Clean the appliance or have it
repaired. Do not place objects
on the control panel.
Installation
Only a qualified electrician should connect
the hob to the mains supply!
The installation should be performed in
accordance with the applicable national and
local regulations. Damage caused by improper
installation or connection is not covered by
the guarantee.
Safety instructions
To enable the appliance to function properly,
please ensure that:
That there is sufficient ventilation to allow
the hob to cool down, in accordance with
the possibilities specified in this chapter.
The ventilation air drawn in by the hob
must not be warmer than 35 °C. Bear this in
mind if the oven is to be built in under the
hob.
That the connecting cable hangs freely and
is not caught by a drawer.
The worktop should be a minimum of 2.8 cm
and a maximum of 5 cm thick.
The worktop is flat.
If the hob is to be built in any nearer than
40 mm from an adjacent wall or kitchen
cabinet, either to the back or side of the
appliance, the wall or cabinet should be
lined with a heat resistant material.
Building-in dimensions and ventilation
600
510
48
560
490
28-50
Fig. 9: Building-in dimensions
The electronics in the appliance require
cooling. The ventilation openings are located
on the underside of the appliance. It must be
possible for cool air to be drawn in through
these openings. The appliance is fitted with
outlet openings at the front. The kitchen unit
will require a few modifications to allow
optimum cooling of the hob.
Saw out the ventilation openings
(min. 100 cm
2
). Ventilation takes place via
plinth and rear of cupboard (see figure 10).
Fig. 10: Ventilation openings
Where there is a drawer, a gap of at least
560 x 6 mm should be made at the front
(see fig. 11). Attention! A drawer may not
close off the ventilation openings on the
underside of the appliance.
Publicité
