JVC DLA-RS66 Manuel D'instructions page 62

Function
Trigger
For configuring 12 V output to an external screen equipped with a trigger function.
Setting
Off
On (Power)
On (Anamo)
Off Timer
For setting the timing to power off the unit automatically ("1 Hour", "2 Hours", "3 Hours", or "4 Hours") when it is not
operated for a period of time.
High Altitude Mode
Set to "On" when using the projector at a location of low atmospheric pressure (higher than 900 m above sea level).
ECO Mode
Setting
On
Off
Communication Terminal
For setting the external control terminal to be used to "RS-232C" or "LAN".
Network
Setting
DHCP Client On
Off
IP Address
Subnet Mask
Default Gateway
MAC Address
Set
62
No output.
Outputs control signals (12 V) from the trigger terminal when the power is turned
on.
After the power is turned off, output stops when the unit shifts to the Standby
0
mode after cooling is complete.
You can also output signals in the Standby mode by pressing the [OK] button.
0
Outputs control signals when the "Anamorphic" setting is switched from "Off" to "A"
or "B".
Minimizes power consumption in the Standby mode.
If there is no signal transmission or operation for 30 minutes while an image is
0
projected, the power is turned off automatically.
Set to "Off" if RS-232C / LAN communication is performed or the HDMI link function
is used in the Standby mode.
Obtains the IP address automatically from the DHCP server inside the connected
network.
For configuring the network settings manually.
For configuring the IP address.
For configuring the subnet mask.
For configuring the default gateway.
Displays the MAC address of the unit.
Applies the network settings.
Description
Description
Description