JVC DLA-RS66 Manuel D'instructions page 22

Connecting the Projector
Do not turn on the power until connection is complete.
0
The connection procedures differ according to the device used. For details, please refer to the instruction manual
0
of the device to be connected.
This projector is used for projecting images. To output the audio of connected devices, please connect a separate
0
audio output device, such as an amplifier or speaker.
The images may not be displayed depending on the devices and cables to be connected.
0
Use only HDMI cables (sold separately) that are HDMI-certified.
Some cables cannot be connected to this unit due to the size of their connector cover.
0
Connecting to the HDMI Input Terminal (Digital Input)
Connecting via HDMI cable
This Unit
To [HDMI 1] or [HDMI 2] input
terminal
.
If noise occurs, move the laptop away from this unit.
0
For a transmission bandwidth in compliance with the HDMI standard, a 340 MHz cable is recommended. When
0
using a cable with a bandwidth of 75 MHz, you are recommended to set the resolution of the equipment transmitting
the video to 1080i or lower.
If the video is not displayed, try to reduce the length of the cable or lower the resolution of the video transmitting
0
equipment.
Connecting via HDMI-DVI conversion cable
This Unit
To [HDMI 1] or [HDMI 2] input
terminal
HDMI-DVI Conversion Cable (Sold Separately)
.
If noise occurs, move the desktop PC away from this unit.
0
If the video is not displayed, try to reduce the length of the cable or lower the resolution of the video transmitting
0
equipment.
22
HDMI Cable (Sold Separately)
BD/DVD Recorder, etc.
HDMI Output Terminal
Desktop PC, etc.
DVI Output Terminal
Laptop, etc.