JVC DLA-RS66 Manuel D'instructions page 27

Turn off the power
3
Remote control: press the B [STAND BY] button
Projector unit: press the A [STANDBY/ON] button
While the "Are you sure you want to turn off?" message is displayed, press the button again.
0
The lamp turns off, and the "STANDBY/ON" indicator switches from a green light to a red blinking light.
0
After the light goes off, the fan will run for about 60 seconds to cool down the lamp (Cool-down mode)
0
Do not disconnect the power cable while cooling is in progress.
After about 60 seconds, the "STANDBY/ON" indicator switches from a blinking red to a solid red light.
0
"STANDBY/ON" blinking (red)
.
(M N) Attach the lens cover.
0
(K L) The motorized lens cover closes.
0
CAUTION
The power cannot be turned off within approximately 90 seconds after it has been turned on.
0
After the light goes off, the fan will run for about 60 seconds to cool down the lamp (Cool-down mode)
0
Do not disconnect the power cable while cooling is in progress.
The power cannot be turned on again while cooling is in progress (60 seconds).
0
Pull out the power plug when the unit is not to be used for a prolonged period of time.
0
In the Cool-down mode
STANDBY/ON LAMP WARNING
"STANDBY/ON" lights up (red)
In standby state
STANDBY/ON TANDBY ND LAMP WARNING
27