Technical Data; Ec Declaration Of Conformity - HSM Classic 104.3 Notice D'utilisation

9 Technical data

Cutting type
Shred size (mm)
Sa fe ty ra ting German DIN 66399
Cutting ca pa ci ty* (Sheet) DIN A4
Weight
Cutting speed
Lo ading width
Voltage
Power for the maximum number of sheets
Operating mode
Dimensions W x D x H (mm)
Ambient conditions in operation:
Temperature
Relative humidity
Height above sea-level (MSL)
Volume of shred. mat. container
Noise level (Idle running/ load)
* The maximum number of sheets (DIN A4, 70 g/m² or 80 g/m²), fed lengthways, which can be cut in one cycle. The
performance data is determined when the motor is cold and the cutting device is freshly oiled. A weaker mains voltage
or a different mains frequency to the one specifi ed could result in less sheet capacity and increased noise during op-
eration. The sheet capacity can vary depending on the structure and properties of the paper and on the way it enters.

EC Declaration of Conformity

The manufacturer HSM GmbH + Co. KG, Austraße 1 - 9, 88699 Frickingen / Germany hereby declares that the
design and construction of the supplied version of the machine HSM Classic 104.3 meet the fundamental health and
safety requirements of the following EC directives:
Low voltage directive 2006 / 95 / EEC
EMC directive 2004 / 108 / EC
Applied standards:
EN ISO 13857 EN 55014-1
EN 60950-1 EN 61000-3-2
Frickingen, 2.6.2014
06/2014
P-2, O-2,
T-2, E-2
70 g/m 22 - 24
2
80 g/m 17 - 19
2
EN 55014-2
EN 61000-3-3
ppa. Hubert Kötzinger - Chief Technical Offi cer (CTO)
Classic 104.3
Strip cut
5.8 3.9
P-2, T-2, P-3, T-2,
E-2
16 - 18 12 - 14
13 - 15
11,5 kg
80 mm/s
240 mm
230 V, 50 Hz
100 V, 50/60 Hz – 115 V, 60 Hz
Continuous operation
375 x 281 x 583
-10 °C to +25 °C
max. 90 %, without condensation
max. 2,000 m
58 dB(A) / 59 - 63 dB(A)
english
Cross cut
1.9 3.9 x 30
P-4, T-4,
E-2 E-3, F-1
12 - 14
9 - 11 9 - 11
12,5 kg
90 mm/s
440 W
33 l
1.9 x 15
P-5, T-5,
E-4, F-2
9 - 11
7 - 9
13