ATIKA BV 315 Notice Originale page 24

Fault
Saw band contorted
Saw band runs out of cutting line
or passes of
Saw vibrates
Sawdust exit blocked
Saw band does not move alt-
hough motor is running
In case of further faults or inquiries please contact your local dealer.
Type / Model
Year of construction
Motor output P
1
Mains voltage
Mains frequency
Idle speed
Fuse protection
Cutting speed
Length of saw band
Width of saw band
Thickness of saw band max.
Saw band roll
Saw table size
Transverse adjustment saw table
Cutting height max.
Width of passageway max.
Exhaust connector
Dimensions (length x width x height)
Weight
Commercial small dust removers or industrial vacuum cleaners can be used for exhaustion.
23
Possible cause
 To high lateral load
 Saw band does not run centrally on the upper
band saw roll
 Insufficient fixation
 Saw table loose
 Fixation screws of motor lose
 No extraction system connected
 Extraction power to weak
 Drive belt lose
 Drive belt defect
Technical data
Removal
 Avoid lateral pressure on the saw band.
 Adjust incline of the upper band saw roll
 Fix saw on suitable ground
 Adjust and fix saw table
 Fasten fixation screws
 Switch off saw, remove sawdust and connect
extraction system
 Switch off saw, remove sawdust and in-
crease extraction power (air speeds  20
m/sec on suction socket of sawdust.
 Clamp drive belt
 Replace drive belt
BV 315
see last page
750 W
230 V
50 Hz
1400 min
–1
10 A slow
370 m/min. & 800 m/min. selectable
2240 mm -10 mm
12.5 ± 1 mm
0.5 mm -0.1 mm
315 mm
400 58 mm
0 – 45 °
155 mm
300 mm

100 mm
720 x 740 x 1670 mm
63 kg
Technical modifications reserved!