Publicité
Les langues disponibles
Les langues disponibles
Hang in the pushing stick in case of non-use in the
mounting on the side of the device.
Do not use the pushing stick when it is damaged and
replace the pushing stick immediately.
Adjusting the upper saw band coping
The upper saw band coping protects against acci-
dental touching of the saw band and flying sawdust.
The height of the upper saw band coping must be adjusted:
Before sawing, to adapt to the work piece height
After changes of saw band (i.e. clamping or replacing saw
band, adjusting saw table)
The distance between saw band coping and work
piece must be 3 mm that there is a sufficient protection
against touching the saw band.
Adjusting:
1.
Release fixation screw (H).
2.
The required position of the saw band coping can be
adjusted with the adjusting wheel (18).
3.
Refasten fixation screw (H).
Cutting round work pieces
Cutting round timber is not allowed with the standard feeding
assistances. When cutting round timber use a special device
which safes the work piece from skewing.
Edgewise cutting of plain work pieces
When sawing edgewise plain work pieces a suitable stop an-
gle for a safe guidance must be used.
Cutting narrow workpieces
(Width less than 120 mm)
Push the work piece with both hands forwards, within the saw
band zone use the pushing stick.
Cutting wide workpieces
With the flat of the hand and the fingers closed, push the work
piece to be cut along the stop.
Cutting long workpieces
Secure long workpieces against dropping down when
finishing the cutting process. Use roller supports or simi-
lar devices for this purpose.
The sawing process
1.
Select and adjust parallel stopper (14) and saw table
incline corresponding to the cutting type.
2. Select and adjust speed of saw band according to the
material.
When sawing with parallel stopper and inclined
saw table the work piece can cant. The parallel stopper
must therefore be fixed on the downwards inclined side of
the saw table.
3.
Adjust distance between saw band coping and work
piece to 3 mm.
4. Put work piece on the saw table.
5. Put in power plug.
6. Switch on saw.
7. Saw through work piece in one work step.
Hint:
Make always a test cut to be able to correct the adjust-
ment.
8. Switch off saw when it is not intended to go on sawing.
Maintenance and cleaning
Before each maintenance and cleaning
work
switch off device
wait for stop of saw
pull out power plug
Further maintenance and cleaning works than described in this
chapter shall only be carried out by the manufacturer or com-
panies named by the manufacturer.
For maintaining and cleaning, removed security devices must
unconditionally be mounted properly and proved again.
Use only original parts. Other parts can result in unexpected
damages and injuries.
Cleaning
Observe the following to maintain the functionality of the
saw.
Do not wash down device with water.
Remove splints and sawdust only with a brush or vacuum
cleaner.
Clean and oil all moving parts regularly.
Never use any grease!
Use for instance sewing machine oil, liquid hydraulic
fluid or environmentally acceptable spray oil.
Provide that the saw band stays rust-free and resin-free.
Remove all resin residues from the saw bench top.
Resin residues can be removed with a commercial
maintenance and care spray.
Treat the surface of the saw table after cleaning with an
anti-blocking agent.
The saw band is a wearing part and becomes edgeless
after longer or more frequent use respectively.
Renew then the saw band.
20
Publicité
