ATIKA BV 315 Notice Originale page 18

Repairs to other parts of the machine must be carried
out by the manufacturer or one of his customer ser-
vice points.
Use only original spare parts, accessories and spe-
cial accessory parts. Accidents can arise for the user
through the use of other spare parts. The manufac-
turer is not liable for any damage or injury resulting
from such action.
► Description of device / spare parts
Pos. Designation
no.
Adjusting wheel for clamping of saw
1
band
2 Upper case door
3 Pushing stick holder
4 Pushing stick
5 Circuit closer/breaker
6 Lower band guidance ►
7 Lower case door
8 Crossfeed stop
9 Belt gear
10 Lower band saw roll
11 Crank for adjusting of belt tension
12 Table insert
13 Saw table
14 Parallel stopper cpl.
14a Guide ruler
14b Stop guide
15 Saw band
16 Upper band guidance
17 Upper band saw roll
18 Adjusting wheel for saw band coping
19 Saw band coping
20 Transverse adjustment saw table
21 Splinters suction socket
22 Base
23 Line cord
24 Motor
25 Adjusting wheel for upper band saw roll
26 Stopper guidance profile
27 Rubber pulley for band saw roll ►
28 Engine belt pulley ►
29 Belt pulley at the lower band saw roll
30 Drive belt
31 Leg
32 Brace
34 Safety label
17



Assemble saw table

the saw table guidance (20).
Order

number
the saw table guidance.

366403
side of the saw table (13).

Adjust saw table

362872 Angle the saw table (13) laterally.
362658
 Release the four fixation screws (C).
362663
 Angle saw table (13) in a way that the saw band is located

in the centre of the table insert.
366405
 Refasten attachment screws (C).

362673
Angle the saw table (13) rectangularly

 Place upper saw band coping completely upwards (see
362666
„Adjustment of the upper saw band coping" p. 19)

 Check saw band tension (see „Saw band tension" p. 17)
362668
 Release fixation screw (D).

 Angle the saw table with the help of an angle rectangular to

the saw band.
362662
 Refasten fixation screw (D).
366406
362672
Release the counter nut (E) and adjust the adjusting screw
366403 (F) until the adjusting screw touches the saw table. Refasten
the counter nut.


Assemble parallel stopper


Assemble stopper guidance profile (26)



366403

16 and washers at the table top.
362685
362687
The parallel stopper (14) is clamped on the saw table. It

can be assembled on the right or on the left of the saw band.

Push the stopper guidance on the corresponding side on
362681
the guidance gib. Fasten the wing nut (A). Mount the stopper

ruler on the side of the stopper guidance which faces towards

the saw band.
362652
Mount the holder (3) for the pushing stick.
Assembly
Fasten the braces (32) to the legs (31).
Fasten the saw on the base frame.
Assemble the handle (11).
Guide saw table (13) over the saw band and put it on
Fasten saw table with four screws and spring rings at
Assemble the end stop screw (M8 x 25) at the bottom
Push the stopper guidance profile (26) on the table top.
Fasten stopper guidance profile with four screws M 8 x