4. Fit a new rubber belt on the band saw roll.
5. Fit the saw band.
6.
Close the case door.
Replace table insert
Replace a worn-out or damaged table insert
immediately.
Push the table insert (12) from below out of the saw table and
replace it by a new table insert.
Transport
Remove mains plug before each
transport.
Transport the saw only with:
the upper saw band guidance positioned completely
downwards
unscrewed jutting out accessories
Before each fault clearance
Switch off device
Wait for stop of saw
Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after
switching on or switches off
during idle running
Motor hums, but does not initiate
Machine stops while cutting
Work piece jams when pushing
forward or pulling backward
Burn marks at the cut edges
Saw band breaks
Possible faults
Possible cause
Power failure
Extension cable defect
Motor or switch defect
Condenser defect
Saw band edgeless
Feed too large
Saw band edgeless
The parallel stopper is not parallel to the saw
band
Saw band is not suitable for the work step or
edgeless
Wrong saw stressing
To high load
Wrong saw band
Storage
Remove the mains plug from the socket.
Store unused equipment in a dry, locked place out of the
reach of children.
To extend the service life of the saw and guarantee smooth
operation, before storing for a longer period
thoroughly clean the saw
treat all movable parts with an environmentally friendly
oil
Never use any grease!
Guarantee
Please note the attached guarantee declaration.
Removal
Check safety fuse
Check cable, no longer use defect cable
Have motor or switch checked by an ap-
proved electrician or replaced by original
spare parts
Condenser should be replaced by customer
service
Replace saw band
Allow the motor to cool off and then continue
work using less pressure
Hold the work piece firmly and switch off the
motor immediately. Then renew the saw
band.
Readjust the parallel stopper.
Replace saw band
Adjust saw band stress
Reduce pressure against the saw band.
Wrong saw band
thin work piece = small saw band
thick work piece = broad saw band
22