ATIKA BV 315 Notice Originale page 15

You may not start to operate the machine until
you have read these operating instructions,
observed all the instructions given and in-
stalled the machine as described!
Keep the instructions in a safe place for future use.
Contents
EC Declaration of Conformity
Extent of delivery
Characteristic noise values
Symbols on the machine / in the operating instructions
Description of device / spare parts
Proper use
Residual risks
Safe working
Assembly
Preparing for startup
Start-up
Settings on the saw
Working with the saw
Maintenance and cleaning
Transport
Storage
Guarantee
Possible faults
Specifications
Extent of delivery

After unpacking, check the contents of the box for
completeness

possible transport damage.

Report any damage or missing items to your dealer, supplier
or the manufacturer immediately. Complaints made at a later
date will not be acknowledged.

Band saw BV 315 (pre-assembled device unit)
 Saw table
 Table insert
 Stopper guidance profile
 Parallel stopper

Crossfeed stop

Pushstick
Characteristic noise values
DIN EN ISO 3744
Application of the machine as band saw with standard saw
band.
Sound power level
L = 100.7 dB(A)
WA
Measuring uncertainty K: 3 dB(A)
The values given are emission values and must therefore not simul-
taneously represent safe workplace values too. Although there is a
relationship between emission and immission levels, it can be relia-
 4 legs
 4 Braces
 Fastener bag
 Operating instructions
 Assembly and operating
instruction sheet

Warranty declaration
Sound pressure level
L = 89.3 dB(A)
pA
bly deduced whether additional precautionary measures are neces-
sary or not. Factors, which can influence the immission level current-
ly existing at the workplace include the duration of the effects, the
special type of the workroom, other noise sources, etc. e.g. the num-
ber of machines and other adjacent processes. The permissible
workplace values can also vary from country to country. This infor-
mation should however enable an improved assessment of the dan-
ger and risk to be carried out.
Symbols operating instructions
1
14
Potential hazard or hazardous situation. Failure to
14
observe these instructions may lead to injuries or
14
cause damage to property.
15
 Important information on proper handling. Failure
15
to observe these instructions may lead to malfunction.
15
16
 User information. This information helps you to use
17
all the functions optimally.
18
Assembly, operation and servicing. Here you are
18
explained exactly what to do.
18
19
Please refer to the attached assembly
20
and operating instruction sheet for refer-
22 ences to figure numbers in the text.
22
...
22
22
23 Symbols on the machine
Read and follow the operating instructions and
safety advices before starting up the machine.
Wear eye and ear protection.
Wear dust mask.
Switch off the motor and disconnect the mains
plug before performing cleaning, maintenance or
repair work.
Do not expose to rain. Protect against humidity.
Risk of injuries of fingers and hands by the saw
band.
This product complies with European regulations
specifically applicable to it.
Electrical devices do not go into the domestic
rubbish. Give devices, accessories and packag-
ing to an ecofriendly recycling.
According to the European Directive 2012/19/EC
on electrical and electronic scrap, electrical devices that are no
longer serviceable must be separately collected and brought to
a facility for an environmentally compatible recycling.
14