Makita DTD173 Manuel D'instructions page 10

When the application mode is not
registered:
The level of impact force changes every time you press
the quick mode-switching button. The front lamp will
flash once when the impact force is changed by press-
ing the quick mode-switching button.
When the application mode is registered:
The tool switches between the registered application
mode and current application mode every time you
press the quick mode-switching button. The front lamp
will flash once when the application mode is changed by
pressing the quick mode-switching button.
NOTE: When the lamp status is off, the front lamp will
not flash even when the application mode is changed
by pressing the quick mode-switching button.
NOTE: Refer to "Registering the application mode"
in "Quick mode-switching function" section for how to
register the application mode.
Quick reference
The following table shows the functions of the quick mode-switching button.
indicates the quick mode-switching button.
Button(s) / Purpose
(When quick mode-switching function
is OFF)
Changing the impact force by the quick
mode-switching button
(When quick mode-switching function
is ON)
Switching to the registered application
mode
Registering the application mode
Erasing the registered application mode
Disabling/resuming the quick
mode-switching button
: The lamp is blinking.
* The front lamp will not flash when the lamp status is off.
Disabling the quick mode-switching
button
You can also disable the quick mode-switching button.
After disabling, the quick mode-switching button will not
work for changing the impact force and switching the
application mode.
To disable the quick mode-switching button, press and
hold the quick mode-switching button and the but-
ton at the same time until the all lamps on the panel
blink.
To resume the quick mode-switching button, perform
the same procedure as above again.
NOTE: Registering and erasing the application mode
can be performed even if the quick mode-switching
button is disabled. After registering or erasing the
application mode, the quick mode-switching button
will be activated.
Action
Press
Press
Press and hold (each button)
Press and hold (each button)
Press and hold (each button)
10 ENGLISH
How to confirm
The front lamp on the tool flash once.*
The front lamp on the tool flash once.*
Example: Wood mode is registered
The lamp of desired application mode
blinks.
All impact force grade lamps blink.
All lamps on the panel blink.