Publicité
Les langues disponibles
Les langues disponibles
Using the Remote Control
Power
1. Press POWER to turn ON air conditioner.
2. Press POWER again to turn OFF the air conditioner.
Cool
Press COOL to enter Cool mode.
Fan Speed
1. Press FAN SPEED until the bar LED on the air
conditioner control panel display for the desired
setting.
2. Choose Low, Medium, or High.
NOTES:
Auto fan speed and Temperature cannot be selected in Fan
■ ■
mode.
In Energy Saver (on some models) and Cool modes, Auto fan
■ ■
speed is selected automatically.
Eco
Conserves energy by turning OFF compressor
■ ■
when room reaches desired temperature.
The fan motor will run for 20 to 40 seconds
and then it will stop, this will repeat to
provide more comfortable feeling and save energy. The
compressor will turn back ON when the room temperature
rises above the set temperature. Press ECO to turn Eco
feature ON and OFF. When the unit is in Eco mode, the light
will turn ON.
Adjusting Temperature
Press the up arrow button to increase the set
temperature. Press the down button to decrease the
set temperature.
NOTE: After 5 seconds, the display on the air
conditioner control panel will show the current room temperature.
Sleep
Automatically adjusts the temperature and fan speed
to make the room more comfortable during the night.
Press and hold the SLEEP button for 10 seconds until
the sleep light turns on. All of the left lights will turn off. The set
temperature will automatically raise by 1.8°F (1˚C) every 30-60
minutes. At most, the temperature will change six times until the
temperature reaches 82°F (28°C). Running time depends upon
the set temperature.
Timer
Delayed Shutoff:
Use the timer to set the air conditioner to turn off
automatically after a 0.5- to 24-hour delay (the air
conditioner must be ON):
1. Press TIMER. The display will show remaining time before the
2. Press the up or down arrow button to change the delayed
3. Press TIMER again to confirm setting.
Delayed Start:
You can also set the air conditioner to turn on automatically after
a 0.5- to 24-hour delay.
NOTE: After the set delay, the air conditioner will turn on with
the previous settings. Change the mode, fan speed, and/or
temperature before setting the timer, if desired.
1. Turn OFF the air conditioner.
2. Press TIMER. Set the temperature by pressing the up or down
POWER
COOL
3. Press TIMER a second time to set the rest time. Press the up
POWER
COOL
POWER
COOL
4. Press TIMER again while the time remaining is shown on the
SLEEP
To Cancel Timer:
After the timer has been set, press TIMER.
ECO
TIMER
DISPLAY
Auto:
FAN
SLEEP
FAN
SLEEP
Press AUTO MODE to enter into Auto mode. In
SPEED
SPEED
this mode, the fan speed and temperature are set
AUTO
MODE
automatically according to the room temperature as
TIMER
ECO
DISPLAY
TIMER
ECO
DISPLAY
tested by the indoor temperature sensor.
POWER
COOL
Heat: Press the HEAT button to Heat mode. It is for heating
AUTO
FAN
model.
MODE
ONLY
AUTO
FAN
MODE
ONLY
Display:
Press DISPLAY to switch on/off all lights or the LED
FAN
SLEEP
display.
SPEED
Fan only:
TIMER
ECO
DISPLAY
Press the Fan Only button to enter Fan Only mode.
AUTO
FAN
MODE
ONLY
POWER
COOL
SLEEP
ECO
TIMER
Use a small Phillips screwdriver to loosen the battery cover
screw. Slide the battery cover down with two thumbs to remove.
Remove and properly dispose of old batteries, then replace with
AUTO
MODE
two new AAA batteries. Replace the battery cover and tighten the
screw.
air conditioner will turn OFF.
shut-off time from 0.5 to 24 hours. The time can be set in 0.5-
hour increments below 10 hours and 1-hour increments for 10
hours or above.
NOTE: The Set light will turn on while setting.
arrow button.
or down arrow button to change the delay time from 0.5 to 24
hours, then press TIMER again.
display.
FAN
SPEED
FAN
ONLY
Replacing the battery
Remove and replace batteries
FAN
SPEED
DISPLAY
FAN
ONLY
SLEEP
TIMER
ECO
DISPLA
AUTO
MODE
POWER
COOL
SLEEP
TIMER
ECO
POWER
COOL
POWER
COOL
AUTO
MODE
FAN
SLEEP
SPEED
FAN
SLEEP
SPEED
ECO
TIMER
DISPLAY
ECO
TIMER
DISPLAY
AUTO
FAN
MODE
ONLY
AUTO
FAN
MODE
ONLY
11
FAN
SPEED
FAN
ONLY
FA
SPE
DISP
FA
ON
Publicité
