Oase Waterfall Spillway with Filtration 16 in. Notice D'emploi page 6

- English -
Installation (cont.)
For mounting to the liner (liner not included)
● After completing the section "Assembling the Spillway
with Filtration"
1. Make sure there is enough liner to line the front of the
spillway without wrinkling or pulling.
● Carefully clean and rinse the liner inside and out with
water, then dry it with paper towels or a clean cloth.
The surface to be sealed must be clean and dry for the
sealer to bond properly.
2. Mark the liner with the shape of the spillway. A white or
yellow marker works well to do this.
Notes: White or yellow marker is NOT INCLUDED.
3. Carefully cut and remove the section of liner in the
spillway opening.
4. Apply a continuous 1/4" bead of sealer around the flange
of spillway.
○ Make sure there are no spaces or voids in the bead
between the holes and the edge of the cut-out on the
flange of the spillway.
Notes: Sealer is NOT INCLUDED.
5. Align the liner on the flange of spillway. Make sure the
liner sits flat on the flange without wrinkling or pulling.
1.
2.
3.
4.
5.
Liner
Apply sealer on
this surface
6