Magmaweld SMART G5550NL Manuel D'utilisation page 30

30 Operation
3.4 Arc Length Adjustment (ArC)
When you press and hold the adjustment knob for 3 seconds, the arc length function will be active. The factory
EN
setting is 0.0. You can change the arc length adjustment in the range of + 7 / -7 by turning the same knob to the
right or left. As it goes towards +7, the wire approaches the nozzle, the arc length increases. As it goes towards
-7, the wire approaches the welding metal and the arc length decreases. After the desired setting is made, the
setting is exited by pressing the same knob.
3.5 MIG Curve
Pre-Gas
Post Gas
Burn Back
Arc On Time
Arc Off Time
Wire Diameter
Thickness
Gas Type
Wire Type
Crater
Mode
Trigger
Method
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
All manuals and user guides at all-guides.com
Set Voltage
Crater Open
Voltage 0 - 25 Slow Release
Pre Gas
On
Set Wire
Slow Release
Crater Closed
Off
Wire 0 - 25
Pre-Gas
Set Voltage
Crater Open
Voltage 0 - 25 Slow Release
Pre Gas
On
Set Wire
Slow Release
Crater Closed
Off
Wire 0 - 25
Pre-Gas
Pnt Mode
On
Spot
Pre-Gas
Value Range
0,0 - 9,9 sec
0,0 - 9,9 sec
25 - 0 - 25
0,2 - 9,9 sec
0,0 - 9,9 sec
0,6 - 2,4 mm
0,6 - 20,0 mm
CO₂, Ar/5-10 CO₂, Ar/15-25 CO₂, Ar/2.5 CO₂, Ar/10-15 CO₂, Argon
Steel, AlMg, FCW, AlSi, FCW-M, CuSi, CrNi, CuAl
Active / Passive
Synergic / Smart / Classic
Method / 2 / 4
MIG/MAG - MMA -
LIFT TIG
Crater
Crater
Pnt Mode
Off
Factory Setting
0,1 sec
0,1 sec
0 step
0,2 sec
0,0 sec
1,0 mm
1,0 mm
Passive
2
MIG / MAG
SMART SERIES / SMART SERİSİ
Burn Back
Post Gas
Burn Back
Post Gas
Burn Back
Post Gas
Burn Back
Post Gas
Post Gas
2- Position MIG 4- Position MIG
www.magmaweld.com