Publicité
Les langues disponibles
Les langues disponibles
SMART SERIES / SMART SERİSİ
Pot (4) is turned right and left for the setting.
4-) ADJUSTMENT POT
• When the MMA welding method is selected, the current is set by the pot.
• When the Lift TIG welding method is selected, the current is set by the pot.
• When the classic mode is selected, the wire speed is set by the pot.
• When the smart mode is selected, the current is set by the pot, the voltage against the adjusted current is
automatically calculated.
• When the synergic mode is selected, the thickness of the material to be pot-welded is selected, the voltage
is automatically calculated according to the set thickness.
• When you press the menu button (6) and go to the functions section, you need to press the pot once and
switch to the other function in order to record in the relevant function.
When the pre gas (PrE) function is selected; (5) if this value is desired to be saved after setting with the pot
Example;
(4) it is necessary to press the pot once and switch to the post gas, namely the other function (PoS). If the
pot (4) is not pressed and next function (PoS) is not activated, and if you return directly to the main page,
there will be no recording.
Pot (5) is turned right and left for the setting.
5-) ADJUSTMENT POT
• When the classic mode is selected, the voltage value is set.
• When smart mode is selected (4), the voltage is automatically calculated against the current set with the
pot. Within certain tolerance range (5) you can set the voltage by turning the pot left and right.
• When synergic mode is selected, voltage is calculated automatically according to set parameters. Within
certain tolerance range (5) you can set the voltage by turning the pot left and right.
• When menu button is (6) selected, functions will appear. Pot related functions are set.
When the button (6) is pressed once, functions will appear. To return to the main page, simply press the
6-) FUNCTION SELECTION
button again. The selected function (5) is set by turning the pot left or right, when you want to save the
selected setting, it is necessary to move to the next function. It is enough to press the pot once to save (4)
so, the setting is saved and the next function is activated. The menu section includes the following functions
respectively:
Pre-gas time is set.
Pre-Gas
PrE
Before starting the welding for the specified time, gas comes in and then the welding
starts. It provides protection of the welding pool when the welding starts.
Post-gas time is set.
Post-Gas
PoS
After the end of the welding for the specified time, gas comes and the welding ends. It
provides protection of the welding pool at the end of the welding.
Burnback adjustment is made.
Burn Back
brn
If the value seen on the screen is "+" in backburning, the wire will come forward for the
specified time, if the value on the screen is "-", the wire will continue to burn back for the
specified time. When the welding process is completed, it prevents the welding wire from
sticking to the contact nozzle.
www.magmaweld.com
All manuals and user guides at all-guides.com
• 0 - 9.9 sec.
Setting Range
• 0 - 9.9 sec.
Setting Range
• + 25 - 25
Setting Range
USER MANUAL | MANUEL D'UTILISATION | РУКОВОДСТВО ПО ЭКСПЛУАТАЦИИ | KULLANIM KILAVUZU
Operation
25
EN
Publicité
