Crivit 311336 Notice D'utilisation page 9

Congratulations!
With your purchase you have decided on a
high-quality product. Get to know the product
before you start to use it.
Carefully read the following
instructions for use.
Use the product only as described and only
for the given areas of application. Keep these
instructions safe. When passing the product
on to a third party, always make sure that the
documentation is included.
Package contents
1 x instructions for use
1 x double-cylinder foot pump
2 x adapter for inflatable items (5)
1 x adapter for balls (6)
Technical data
Rated pressure: 5 bar/73 PSI
Dimensions: approx. 285 x 143 x 88mm
(L x W x H)
Date of manufacture (month/year):
01/2019
Intended use
This item is suitable for private use for inflating
all common bicycle tires with Schrader valves,
Dunlop valves and Presta valves. It may also be
used for inflating balls, air mattresses and similar
inflatable items.
Safety information
Risk of injury!
• This product is not suitable for use by children
or people with physical and/or mental impair-
ments due to the item's high operating forces
and their associated risks.
• Check the item and especially the connec-
tion points for damage or wear before each
use. Defective items may no longer be used
and must be disposed of as they cannot be
repaired.
• Risk of burns! During prolonged pumping,
the pump plunger and the pump cylinder can
become hot due to the friction. The pump may
only be held by the foot pad after using it.
• There must be a cooling down phase of 2
minutes after pumping 80 times. Inflate an
item only up to the maximum pressure spec-
ified by the manufacturer. In case of bicycle
tyres, this is usually found on the tyre wall.
• While you are inflating, pay attention to the
pressure reading on the pump and to the item
being inflated. There is a risk of an explosion
if there is excess pressure!
• A calibrated pressure gauge must be used to
monitor the pressure while inflating.
Initial setup
Warning! The item is pre-tensioned with
a spring and rebounds quickly when
opening it.
Place the item on the floor. Press the foot pad (1)
down with one hand and unlock the retaining
bracket (2) with the other hand (Fig. B).
Proceed in the reverse order to lock the pump.
Use
The item may only be used on a level, stable
surface. There should be no kinks in the pump
hose (3). Press the foot pad evenly and not too
quickly to inflate an object. Put pressure on the
middle of the foot pad to prevent tilting.
Note: There is a red mark (9) in the shape of
an arrow on the pressure gauge display. Using
this red mark, you can set the desired maximum
pressure as a visual marking.
To do this, turn the housing of the pressure
gauge left or right (Fig. C).
Please note that the adjusted display only serves
as a guide and does not affect the pumping.
Inflating balls (Fig. D)
Put the adapter for balls (6) into the large open-
ing (8) on the dual pump head.
Flip the clamping lever (4) up to lock the adapt-
er in place. Then insert the adapter into the ball.
• Crushing hazard!
For foot operation only.
Not suitable for use by
hand.
GB/IE 11