Publicité
Les langues disponibles
Les langues disponibles
Remove exhausted batteries/rechargeable
batteries from the product immediately.
Initial use
Q
Note: Remove the packaging material before
using the product for the first time.
Inserting/changing the batteries
Q
Turn the battery compartment lid
wise and remove it (see Fig. D1).
Insert the batteries into the battery compartment,
taking their polarity (+ and –) into account
(see Fig. D2).
Replace the battery compartment lid
tighten it by turning it clockwise (see Fig. D3).
Attaching the product
Q
Remove the protective film from the respective
adhesive pad
. Then affix the LED light
2
a level and dry surface (see Fig. B1, B2).
Switching On/Off
Q
To switch the product on press the transparent
body
in the centre of the LED light
4
Fig. C).
When pressing again the product will be
switched off.
Troubleshooting
Q
This product has delicate electronic components.
This means that if it is placed near an object that
transmits radio signals, it could cause interference.
Electrostatic charge can lead to the product
failing. In cases of the product failing to work
remove the batteries for a short while and then
replace them.
Cleaning and care
Q
anticlock-
3
Use a dry, lint-free cloth to clean and take care
of the product.
Do not clean the product with water or other
liquids.
and
Under no circumstances should you use aggressive
3
detergents or abrasives in order to avoid dam-
aging the material.
Disposal
to
The packaging is made entirely of recyclable materials,
1
which you may dispose of at local recycling facilities.
b
a
(see
1
Observe the marking of the packaging
materials for waste separation, which are
marked with abbreviations (a) and num-
bers (b) with following meaning: 1–7:
plastics/20–22: paper and fibreboard/
80–98: composite materials.
GB/IE/NI
9
Publicité
