Parkside PDST 20 A1 Instructions D'utilisation Et Consignes De Sécurité page 10

3. Operation
Hold the hose 4 when unrolling and rolling up
so that the hose 4 cannot injure anyone while
swinging about.
Pay attention to the maximum working pressure
of the hose 4 . Only operate the hose 4 wit-
hin the given parameters (see Technical data).
1. Slowly unroll the desired length of hose through
the hose guide 5 .
2. Plug the hose 4 into the compressor.
3. Connect the compressed air tool by means of the
fast coupling 3 .
4. Remove the tool from the hose 4 after the work
has been completed by pulling the coupling 3
backwards hard.
Roll up the hose 4 again when the job is done.
10 GB/IE/NI/CY/MT
5. Adjust holder
3 4
4. Maintenance, Cleaning and
Disconnect the hose reel from the compressed air
source before you begin to maintain it.
The holder 6 for the air hose reel is on the
back of the device. To apply the holder pull the
plastic downwards and to release pull the plastic
up again.
Storage
If the hose 4 is dirty, clean it before you roll
it up again. Never use aggressive cleaning
materials!
Regularly check that the hose 4 is airtight.
Regularly lubricate the moving parts of the hose
drum.
Immediately change defective and damaged
parts.
When not in use, roll up the hose 4 completely
and store it in a dry, clean and frost-proof place.
6