Publicité
Les langues disponibles
Les langues disponibles
GB
13. Do not use metallic cutting reels or
saw blades. Note that the equipment
remains in operation for a few sec-
onds after the switch is released.
14. Switch off the engine when:
-
Refuelling the equipment,
-
Not using it,
-
Leaving it unattended,
-
Cleaning it,
-
Transporting it from one location to
another,
-
Removing or replacing the cutting de-
vice and manually adjusting the length
of the cutting thread.
96
Precautions to Prevent Recoil
In case of recoil, the user re-
ceives a powerful jolt from the
motorised strimmer. This may
result in loss of control of the
equipment and in serious injury.
Recoil can be avoided by care
and correct technique.
When the metal cutting blade is used,
there is a risk of recoil if the blade edge
hits an obstacle (stone, wood).
•
Hold the equipment firmly in both
hands.
•
Ensure that there are no obstacles on
the ground and do not use the metal
cutting disk near fences, metal posts
or similar.
Symbols in the Instructions
Warning signs with details for
the prevention of personal and
property damage.
Command signs (instead of the
exclamation mark, the command is
explained) with details for the pre-
vention of damage.
Information signs with information
for better handling of the equip-
ment.
Use only well sharp-
ened tools. To cut
thick stems, place
the equipment in po-
sition A.
Publicité
