Publicité
Les langues disponibles
Les langues disponibles
Storage During Working
Breaks
Non-observance of the storage
instructions can cause starting
problems or permanent damage
as a result of fuel residues in the
carburettor.
1. Drain the fuel tank in a well-ventilated
place.
2. Start the engine and allow it to tick
over until the engine stops and the
carburettor is free of fuel.
3. Allow the engine to cool (approx. 5
minutes).
In case of working breaks of more
than 3 months:
4. Loosen the spark plug with a spark
plug wrench (see "Changing/Adjust-
ing the Spark Plug").
5. Pour a teaspoon of pure 2-stroke oil
into the combustion chamber and pull
the starter cable slowly several times
to distribute the oil inside the engine.
6. Reinsert the spark plug.
Replacement parts/
Accessories
Spare parts and accessories can
be obtained at
www.grizzly-service.eu
If you do not have internet access, please
contact the Service Centre (see "Grizzly
Sercice-Center").
Alternatively, you can obtain a 2.5 mm
thick nylon thread from specialist retailers
and wind this onto the thread reel yourself.
Ensure that the thread lies parallel in the
two thread channels and is wound in the
opposite direction to the engine rotation
direction. The engine rotation direction is
indicated with an arrow on the protective
cover.
Furthermore, the thread reel must not be
overfilled, otherwise the thread mecha-
nism will not function correctly.
Disposal/Environmental
Protection
Do not allow used oil and petrol residues
into the sewer system or drains.
Dispose of used oil and petrol residues
in an environmentally friendly way – take
them to a disposal point.
Take the equipment, accessories and pack-
aging for environmentally friendly recycling.
Machinery does not belong in do-
mestic waste.
Drain the petrol tank carefully and take
your equipment to a recycling point. The
plastic and metal components used can
be separated by type and therefore re-
cycled. We will dispose of the defective
equipment you send in, free of charge.
Ask your dealer about this.
Guarantee
• We guarantee this equipment for 24
months. Commercial use will invalidate
the guarantee.
• The guarantee does not cover damage
caused by natural wear, overloading or
improper use. Certain components are
subject to normal wear and not covered
by the guarantee. These specifically
include the: metal cutting blade, thread
reel, cutting thread, thread cutter, air
filter and spark plug.
GB
109
Publicité
