Viking RVRF3361 Guide D'utilisation page 9

Removing the Doors
Getting through narrow spaces
If your refrigerator will not fi t through an entrance area,
before installing the door handles, you can remove the
doors. Check fi rst by measuring the entrance.
To prepare for removing the doors:
1. Make sure the electrical power cord is unplugged from
the wall outlet.
2. Open the freezer drawer and remove the toe grille (see
"Installation" section).
3. Remove any food from the door shelves and close the
doors.
To remove the top hinge covers:
1. Remove the two screws from each cover over the top
door hinges.
2. Lift inside edge of hinge cover and tilt back.
Front
Cover Screw
Top Hinge
Cover
Hinge
Screws
Multi-wire
Cables
Leave
Hinge
With
Door
Front
Rear
Cover Screw
Cover
Screw
Ground
Top
Screw
Hinge
NOTE
DO NOT remove the ground screw from hinge.
To remove the refrigerator doors:
1. Trace lightly around the door's top hinges with a pencil.
2. Disconnect the harness by grasping both sides of the
Rear
Cover
Screw
Ground
Screw
Top
Hinge
Water
3. Detach the water tube from the connector located
Line
Top Hinge
Cover
Hinge
Screws
Use care while pulling the water tube from the unit to
be sure that you do not kink the tube.
Leave
Hinge
With
Door
You will be pulling approximately fi ve feet of water
tube from the back of the refrigerator.
9
This makes reinstallation easier.
connector fi rmly, depress the latch, and pull apart.
Remove the two screws from the top hinge. Lift the door
off of the bottom hinge and set it aside.
behind the refrigerator and pull the tube back out to
the front of the unit. The connector releases when you
press inward on the outer sleeve while pushing the tube
toward the connector then while continuing to hold in
the sleeve, pull the tube away.
NOTE
Press
Press
Water
Line
NOTE
Approximately
5 feet