Opening And Closing The Camera; Inserting The Batteries/Connecting Power Supply - Kompernass WK 5 A2 Mode D'emploi

Opening and closing the camera

The control buttons, connections and the battery compartment are
inside the camera.
GB
♦ Undo both of the side locking clamps
IE
♦ To close the camera, hook the metal bars of the locking clamps
into the brackets and then press the plastic latch downwards.
There is a locking eyelet
which you can securely close the camera with the help of a padlock.

Inserting the batteries/connecting power supply

♦ To insert batteries
♦ Now press the latch on the upper side of the battery compart-
ment down a little way and lift the battery compartment cover off.
♦ Insert 4 or 8 x 1.5 V AA/mignon batteries into the battery com-
partment
NOTICE
► When using 4 batteries, these can either all be inserted in the
upper part or all in the lower part of the battery compartment.
Other combinations are not possible.
♦ Close and secure the battery compartment. Ensure that the bat-
tery compartment cover clicks firmly in place.
♦ If you are operating the device on a mains adaptor (not sup-
plied), open the rubber seal on the bottom of the camera and
insert the plug of the AC adapter cable into the DC socket
The mains adapter must supply a direct-current voltage of 6 V
with at least 1.5 A. Use a barrel jack whose interior polarity is
connected to the plus pole (
56
between the two locking clamps with
5
in the device, open the camera.
35
. Ensure that the polarity is correct.
11
to open the camera.
12
).
.
20
WK 5 A2