Assembly; Setting The Camera Position; Connecting The Camera - Kompernass UK 8 A1 Mode D'emploi

Assembly

NOTE
► Mount the camera so that it can be reached without aid. The
same applies to the connecting cables. These should ideally
be laid in plastic or metal ducting.
► The camera is not suitable for ceiling mounting as the image
can not be rotated.
CAUTION
► When selecting a mounting location for the camera, ensure
that it is not subjected to direct sunlight, vibrations, moisture,
dust, heat or cold.
♦ Using the wall bracket as a template, mark the positions for the
drill holes on the wall.
♦ Drill three holes (ø 6 mm) and insert the wall plugs supplied.
When drilling, ensure that you do not inadvertently damage
power, gas or water lines.
♦ Screw the wall bracket to the wall using the supplied screws.

Setting the camera position

♦ Loosen the locking screw
bracket and align the camera accordingly.
♦ Re-tighten the locking screw

Connecting the camera

The camera has a connecting cable with two cinch sockets
and a low voltage socket
♦ Connect the camera to the corresponding connections
on the extension cable
♦ Connect the cinch plugs
cable to the audio and video inputs of your display device
(e.g. a monitor). If you require audio transmission, the audio con-
nection can be left open.
UK 8 A1
and the knurled nut
and the knurled nut
.
.
+ (video and audio) on the extension
on the wall
.
+
to
43
GB