Kompernass WK 5 A2 Mode D'emploi page 74

CAUTION
► Ensure that there are no electric lines, water or heating pipes
installed at the proposed drilling location!
GB
► The supplied anchors are only suitable for mounting on
IE
concrete or stone. Before starting the installation, please check
your installation location carefully for its suitability for the an-
chors. The assembly material must be suitable for the respective
location. If in doubt, consult a professional.
♦ Mark the drill holes
the desired mounting location and marking the hole positions.
♦ Use a drill with a 6 mm drill bit to drill the required holes and
insert the plugs and insert the anchors
♦ Screw the wall bracket to the wall using the supplied screws
♦ Mount the camera with the tripod thread
and screw the camera a little way on (about three turns).
22
♦ Turn the camera in the desired direction and lock it with the lock-
ing washer
♦ To move the camera into its final position, undo the two joint
wing screws
by tightening the two joint wing screws.
70
by holding the foot of the wall bracket at
25
.
23
a little, position the camera and fix the position
24
flush with the wall.
26
on the tripod screw
21
WK 5 A2
.
27