Opening And Closing The Camera; Inserting The Batteries/Connecting Power Supply - Kompernass WK 8 A1 Mode D'emploi

Opening and closing the camera

The control buttons, connections and the battery compartment are
inside the camera.
♦ Undo both of the side locking clamps
♦ To close the camera, hook the metal bars of the locking clamps
into the brackets and then press the plastic latch downwards.
There is a locking eyelet
which you can securely close the camera with the help of a padlock.

Inserting the batteries/connecting power supply

♦ To insert batteries
♦ Now, press the latch on the underside of the battery compartment
cover down a little way and lift the battery compartment cover off.
♦ Insert 4 or 8 x 1.5 V AA/Mignon/LR6 batteries into the battery
compartment
NOTICE
► When using 4 batteries, these can either all be inserted in the
upper part or all in the lower part of the battery compartment.
Other combinations are not possible.
♦ Close and secure the battery compartment. Ensure that the bat-
tery compartment cover clicks firmly in place.
♦ If you are operating the device on a mains adaptor (not supplied),
open the rubber seal on the left side of the camera and insert the
plug of the AC adapter cable into the DC socket
adapter must supply a direct-current voltage of 6 V with at least
1.5 A. Use a barrel jack whose interior polarity is connected to
the plus pole (
│ GB │ IE
■ 58
4
between the two locking clamps with
35
in the device, open the camera.
11
. Ensure that the polarity is correct.
).
12
to open the camera.
16
. The mains
WK 8 A1