Troubleshooting; Fault Causes And Rectification - Kompernass WK 5 A2 Mode D'emploi

Troubleshooting

This section contains important information about fault identification
and rectification. Follow the instructions to avoid hazards and damage.
GB
IE
WARNING
Observe the following safety information to avoid hazards and
property damage:
► Repairs to electrical devices should only be carried out by
specialists trained by the manufacturer. Improper repairs can
cause considerable risks to users and damage to the device.
Fault causes and rectification
The following table will help to identify and rectify minor malfunctions:
Malfunction
The camera does
not work.
The images are
overexposed.
78
Possible cause
No batteries inserted.
The batteries are
exhausted.
The camera is pointing
at reflective objects.
Direct sunlight may be
shining onto the device,
possibly only at certain
times of the day (pay
attention to the position
of the sun).
Remedy
Insert 4 x 1.5 V batteries
into the battery compart-
ment 11 .
Replace the batteries. If
you are unsatisfied with
the service life of the bat-
teries, insert an additional
4 x 1.5 V batteries in the
battery compartment.
Change the alignment of
the camera.
WK 5 A2