Black & Decker BDH1725SM Mode D'emploi page 6

sWItchInG on and off - fig. h
cautIon:
do not use the unIt uPsIde doWn.
notIce:
When the steam mop is first
turned on the water reservoir will glow red.
Once the steam mop is ready to use the water
reservoir will glow blue. It takes approximately
15 seconds for the steam mop to heat up.
• To switch the appliance on, press the ON/
OFF button (1).
• To switch the appliance off, press the ON/
OFF button.
notIce:
Never leave the steam mop in one spot on any surface for any period of time.
Do not store with a wet pad as this can damage your floor. always place the steam mop
with the handle (4) in the upright position when stationary and make sure the steam mop is
turned off when not in use.
notIce:
always empty the water tank after use.
smartselect
tM
The steam mop is equipped with a SmartSelect
surface cleaning applications. They are used to select the correct operating mode for
your particular hard floor surface.
notIce:
Do not use on any unsealed hard floor surfaces. additionally, on surfaces
that have been treated with wax or some no wax floors, the sheen may be removed
by the heat and steam action. It is always recommended to test an isolated area of
the surface to be cleaned before proceeding. We also recommend that you check
the use and care instructions from the floor
manufacturer.
using the smartselect
from one of the following applications:
The steam mop will select the correct volume
of steam required for your particular cleaning
operation.
notIce:
This unit will kill 99.9% of bacteria and germs when used in accordance with
this manual and with the micro fiber pad fitted and a continuous run time of 90 seconds.
GeneraL use
cautIon:
WarnInG:
water tank and continue to sanitize/ clean, see the Filling Water Tank section.
notIce:
Never leave the steam mop in one spot on any surface for any period of time.
Do not store with a wet pad as this can damage your floor. always place the steam mop
with the handle (4) in the upright position when stationary and make sure the steam mop is
turned off when not in use.
• Always vacuum or sweep the floor before using the steam mop.
• The easiest way to use the steam mop is to tilt the handle to a 45˚ angle and clean
slowly, covering a small area at a time.
• Do not use chemical cleaners with your steam mop. To remove stubborn stains
from vinyl or linoleum floors, you can pre-treat them with a mild detergent and some
water before using the steam mop.
oPeratIon
for fLoor use onLy;
dial
dial (2), choose
tM
hInts for oPtIMuM use
Never use the steam mop without first attaching a cleaning pad.
It is important to monitor the water level in the water tank. To refill the
h
dial (2) which shows various hard floor
TM
6