Rittal DK 7030.022 Notice D'installation Et D'utilisation page 17

3.3 Operating conditions
The CMC III PU 19" Edition may be operated only under the operating conditions listed in section 8
"Technical specifications".
3.4 Base configuration
As standard, the CMC III PU 19" Edition is activated to automatically obtain an IPv4 address from a
DHCP server in the network. If no DHCP server is available, the following base configuration is preset:
IP address:
Netmask:
Gateway:
Security PIN:
Speeds
Ethernet 1 and 2 (RJ 45):
If the CMC III PU 19" Edition cannot be included in the network with these settings, they can be
changed via the display or the CMC III PU 19" Edition website (see section 6).
4 Assembly notes
The CMC III PU 19" Edition is assembled using the brackets supplied loose as accessories as shown
in fig 2, 3 and 4.
5 Installation and operation
5.1 Operating and display elements
The operating and display elements are shown in fig. 5.
Key to fig. 5
1 "Esc" key
2 "Up", and "+" key when entering the pin.
3 Display
4 "Return" key
5 "Down", "Next" key and "–" key when entering the pin.
6 Reset button to restart the CMC III PU 19" Edition
7 Green LED to indicate the power supply
8 Multi-LED for status display
9 Ethernet interface 1 RJ 45
10 Ethernet interface 2 RJ 45
11 RS232 serial interface
12 CAN bus connection (daisy chain) for CMC III sensors, 24 V
13 Digital input
14 Alarm relay output, max. 48 V DC / 2 A
15 USB connection for firmware updates and for data logging
Rittal CMC III Processing Unit 19" Edition
Product description, Assembly notes, Installation and operation
192.168.0.200
255.255.255.0
0.0.0.0
1221
10 / 100 / 1000 Mbit/s
,1 A
EN
17