Geberit AQUACLEAN CAMA Mode D'emploi page 169

5
Connect your Geberit AquaClean Cama
using [Connect now].
✓ The connection is established. This can
take several seconds.
✓ The Geberit AquaClean Cama is ready
for operation.
ATTENTION
Device does not connect to the Geberit Home
app
The Geberit AquaClean device does not connect
to the Geberit Home app within the next ten
minutes or needs to be connected to a second
smartphone.
▶ Disconnect the mains plug and plug it back in
after approximately 30 seconds. Then press
the <+> button on your remote control for
approximately 10 seconds to restart the pairing
process.
27021605942272651 © 07-2024
970.389.00.0(03)
Water leakage – situation and
solutions
If the device tips over and water leaks out, the
technics assembly could come into contact with
water. Proceed as follows if the technics assembly
comes into contact with water:
1
Disconnect the device from the power
supply.
2
Ensure that the technics assembly is not in
the vicinity of leaking water.
3
If the technics assembly has come into
contact with water, allow it to dry out fully.
4
Dry the floor fully to ensure there is no more
residual water.
5
Once the device is dry and there is no more
water in the vicinity, re-install it according to
the instructions in the user manual.
If the Geberit AquaClean device shows
signs of damage, contact Geberit or return
the device immediately to Geberit.
EN
169