Makita LS003GZ01 Manuel D'instructions page 34

In the case of left bevel cut
(a) (b)
1. Inside corner 2. Outside corner
Table (A)
– Molding Bevel angle
posi-
52/38°
tion
type
in the
figure
For (a) Left
inside 33.9°
corner
(b)
For (c)
outside
(d)
corner
Table (B)
– Molding
position in
the figure
For inside (a)
corner
(b)
For outside (c)
corner
(d)
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
• Tilt and secure bevel angle setting to 33.9° LEFT.
• Adjust and secure miter angle setting to 31.6°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its CEILING
CONTACT EDGE against the guide fence on the
saw.
• The finished piece to be used will always be on
the LEFT side of the blade after the cut has been
made.
(c) (d)
1 2
Miter angle
45° type 52/38°
type
Left 30° Right
31.6°
Left
31.6°
Right
31.6°
Molding Finished
edge against piece
guide fence
Ceiling Finished
contact edge piece will be
should be on the Left
against guide side of blade.
fence.
Wall contact
edge should
Finished
be against
piece will be
guide fence.
on the Right
Ceiling side of blade.
contact edge
should be
against guide
fence.
In the case of right bevel cut
1. Inside corner 2. Outside corner
Table (A)
–
45° type
Right For
35.3° inside
corner
Left
35.3°
For
outside
Right
corner
35.3°
Table (B)
–
For inside
corner
For outside
corner
Example:
In the case of cutting 52/38° type crown molding for
position (a) in the above figure:
• Tilt and secure bevel angle setting to 33.9° RIGHT.
• Adjust and secure miter angle setting to 31.6°
RIGHT.
• Lay crown molding with its broad back (hidden)
surface down on the turn base with its WALL
CONTACT EDGE against the guide fence on the
saw.
• The finished piece to be used will always be on
the RIGHT side of the blade after the cut has been
made.
34 ENGLISH
(a) (b) (c) (d)
1
Molding Bevel angle
posi-
52/38° 45° type
tion
type
in the
figure
(a) Right Right
33.9° 30°
(b)
(c)
(d)
Molding Molding
position in edge against
the figure guide fence
(a) Wall contact
edge should
be against
guide fence.
(b) Ceiling
contact edge
(c)
should be
against guide
fence.
(d) Wall contact
edge should
be against
guide fence.
2
Miter angle
52/38° 45° type
type
Right Right
31.6° 35.3°
Left Left
31.6° 35.3°
Right Right
31.6° 35.3°
Finished
piece
Finished
piece will be
on the Right
side of blade.
Finished
piece will be
on the Left
side of blade.