Publicité
Les langues disponibles
Les langues disponibles
EN
Installation procedure
Before you begin assembling the drawers of the appliance, make sure there is enough room to fit the drawer and the appliance.
The precise dimensions for the installment are indicated in inches and mm.
Install an anti-tip block against the rear cabinet wall. Verify screws are adequately secured and do not penetrate electrical wiring or plumbing.
• Turn power off to the electrical outlet.
• Insert plug into three-prong, grounded outlet (see "Power
Requirements and Grounding" on page 2 for electrical
specification).
• Position the drawer so that it is directly centered and slide warming
drawer assembly into cutout until it is flush with cabinet.
• Avoid pinching the power cord between the unit and cabinet wall.
• Open the warming drawer to full extension and fix the structure to
the wall with the four screws provided.
16
=
22 7/8"
=
(580)
INSTALLATION
• Turn power back on to the electrical outlet.
• Turn the warming drawer on. Close the drawer for approximately 1
minute then check for warmth.
Publicité
