Publicité
Les langues disponibles
Les langues disponibles
EN
Amperes
9.2
Installation notes
1. The warming drawer support surface must be a minimum 3/4"
(2cm) thick plywood platform.
It must support 100 pounds.
The platform must be solid, level and flush with the bottom of the
cabinet cut out.
2. Use extreme caution when moving or installing the drawer. It is very
heavy.
DO NOT LIFT THE WARMING DRAWER BY THE DRAWER
HANDLE.
3. Be very careful when moving or installing the warming drawer to
avoid damage to the frame or damage to the cabinets.
4. For best performance results make sure the warming drawer is
leveled before completing installation. There is no way to level the
warming drawer after it has been installed. If the installation is not
level, the door may slide open or not seal tightly, allowing heat to
escape.
NOTE: If installing the warming drawer below another product,
refer to that product's literature for any installation requirements.
5. Be careful when placing drawer. DO NOT pinch the conduit
between the drawer back.
WARNING
Before installing or removing, turn power OFF at the service
panel. Lock service panel to prevent power from being turned ON
accidentally.
Securely fasten drawer to cabinet using the screws provided.
Failure to do so could result in warming dreawer moving or tipping
during use and causing damage to the drawer or cabinets or
personal injury.
Know how to disconnect the power to the warming drawer at the
circuit breaker or fuse box in case of an emergency.
CAUTION
Unit is heavy and requires at least two people or proper
equipment to move.
10
Watts
1 100
INSTALLATION OPTIONS
INSTALLATION BELOW A SINGLE OVEN
24" (610) Min. Inside
Oven
Cutout
9-1/4"
(235)
28-3/8"
(722)
1" Min. Above Toekick or Adjust o Oven Installation Height
INSTALLATION BELOW A DOUBLE OVEN
24" (610) Min. Inside
Oven
Cutout
9-1/4"
(235)
28-3/8"
(722)
1" Min. Above Toekick
Allow 5/8"
Overlapon All Sides
3/4" Min.
(20) Min.
Allow 5/8" Overlap
on All Sides
3/4" Min.
(20) Min.
Publicité
