Publicité
Les langues disponibles
Les langues disponibles
To lubricate the gear housing
WARNING:
housing immediately after operation of the
product. The gear housing is hot and can
cause injury.
•
Use Husqvarna special grease. Speak to your
servicing dealer for more information about
recommended grease.
•
Add the grease through the grease nipple.
CAUTION:
fully.
Blade
Problem
The blade moves slowly or
does not move.
The blade does not cut
easily.
The blade becomes hot.
User interface
Problem
Battery LED indicator flashes or-
ange
2129 - 005 -
Do not touch the gear
Do not fill the gear housing
Troubleshooting
Possible causes
The blade is blocked or it is
damaged.
The blade is not sharp or it
is damaged.
There is friction between
the blades.
Possible faults
Low battery voltage.
To examine the blades
1. Remove the cap on the socket of the gear housing.
2. Put the T27 torx key in the socket of the gear
housing and turn clockwise and counterclockwise.
Make sure that the blades move freely.
3. Examine the edges of the blades for damages and
deformation.
4. Use a file to remove burrs on the blades.
Recommended step
Clean the blades from unwanted materials. Refer to
clean and lubricate the blades on page 14 . Remove
burrs from the blade, refer to
page 15 . Replace the blade if it is damaged.
Sharpen the blade, refer to
page 15 . Replace the blade if it is damaged.
Remove burrs from the blade and lubricate the blade.
To clean and lubricate the blades on page 14 .
Refer to
Possible action
Charge the battery.
To examine the blades on
To examine the blades on
To
15
Publicité
