Maintenance; Replacing The Remote Control Battery; Replacing The Safety Edge Transmitter Battery; Replacing The Integrated Light Bulb - SOMFY ROLLIXO io Manuel D'utilisation

Rollixo io
Diagnostics
Consequences
Actions
Photoelectric
cells
Diagnostics
Consequences
Actions
If a fault is still present on your installation, please contact your installer.

6 - MAINTENANCE

6.1 Replacing the remote control battery

> Keytis
> Keygo

6.2 Replacing the safety edge transmitter battery

Only use an AA 3V6 lithium battery (Somfy part number 1782078).
AA 1V5 alkaline batteries are not compatible.
4 screws
5
Indicator light status
Cell fault
Opening ok
Closing by pressing and holding down
the button within sight of the door
Check that no obstacle is cutting across
the cell beam
Obstacle detection
Remove the obstacle by full automatic
opening
Check that no obstacle is cutting across
the cell beam.
WARNING

6.3 Replacing the integrated light bulb

[1]. Remove the integrated light bulb.
Prog
[2].
An LED bulb of the same type as that supplied (E14 - 1.4W - 230V) must be
used. Using another type of bulb may cause high dangerous overheating.
[1]

6.4 Checking the obstacle detection operation

Every month, check that the door reverses its movement when it encounters an
obstacle which is at least 50 mm high placed on the ground.
6.5 Checking the safety devices (cells)

7 - TECHNICAL DATA

GENERAL SPECIFICATIONS
Power supply
Climatic operating conditions
Somfy radio frequency
Number of storable remote controls
WARNING
[2]
- 20°C/+ 60°C - IP 20
< 25 mW
30
Copyright © 2014 Somfy SAS. All rights reserved.