Publicité
Les langues disponibles
Les langues disponibles
to the clamp adjustment
13
clamp handle
to lock the pipe into position. Force
may be required.
To remove the clamp from the pipe, pull back on the clamp
14
handle release lever
and release the clamp handle.
Fig. E
12
20
28
11
D
WALT Bluetooth® Tool Tag Ready (Fig. F)
e
Optional Accessory
WARNING: Read instruction manual for the D
Bluetooth® Tool Tag.
WARNING: Unplug the charger before installing the
D
WALT Bluetooth® Tool Tag.
e
WARNING: When installing or replacing the D
Bluetooth® Tool Tag, use only the screws provided. Be
sure to securely tighten the screws.
Your pipe threader comes with mounting holes
fasteners for installing a D
(DCE041). You will need a T15 bit tip to install the tag. The
D
WALT Tool Tag is designed for tracking and locating
e
professional power tools, equipment, and machines using
the D
WALT Tool Connect™ app. For proper installation of
e
the D
WALT Tool Tag refer to the D
e
Fig. F
11
and push down on the
21
WALT Bluetooth® Tool Tag
e
WALT Tool Tag manual.
e
21
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. G)
nOTE: The DCE700 uses the DCB609G battery pack only. For
best results, make sure your battery pack is fully charged.
10
Unlock battery door
toward the rear of the tool and open as shown in Figure G.
To install the battery pack
battery pack with the rails inside the tool and slide it in
13
until the battery pack is firmly seated. Ensure that it does
not disengage.
Close the battery door
4
latch
forward toward the front of the tool to lock the
14
battery door.
To remove the battery pack from the tool, unlatch and open
the battery door. Then press the battery release button
and firmly pull the battery pack out of the tool. Insert it into
the charger as described in Charging a Battery.
WALT
e
Do not leave the battery door open.
Fig. G
3
WALT
e
and
Proper Hand Position (Fig. H)
WARNING:To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
WARNING: Always use a support.
Proper hand position requires one hand on the main
2
handle
while the other hand presses the die arm
6
oils the die
3
by moving battery door latch
22
into the tool, align the
3
, and push the battery door
.
English
4
23
23
22
4
8
or
9
Publicité
