Parkside PDB 100 A1 Traduction Des Instructions D'origine page 23

-1
min
3000
2500
2000
1500
1000
500
0
0 100
The workpiece diameter is indicated on the
X-axis. The Y-axis represents the speed.
Start with the diameter of the workpiece and
follow it upwards vertically, then read the
speed where the vertical line meets the curve.
1. Loosen the two locking screws (20) on
the two gear covers (21).
2. Open the gear covers (21).
3. Loosen the retaining screw (22) on the
motor unit using the Allen key (12).
4. Using the lever (24), lift the motor unit
(23) to release the load on the V-belts
(26).
5. Tighten the retaining screw (22) on the
motor unit (23).
6. Place the V-belt (26) on the desired
notch on the drive pulley (25) to reach
the specified speed:
2600
1760
The V-belt must be on the same
notch of both the upper and lo-
wer drive pulley.
The two gear covers (21) are equip-
ped with a locking switch (27). The
locking switches (27) are automa-
tically actuated when closing the
gear covers (21). If the gear cover
(21) is not closed correctly, the de-
vice cannot be switched on.
200 300 400
mm
1260
890
7. Loosen the retaining screw (22) and
lower the lever with the motor unit to
clamp the V-belt.
8. Tighten the retaining screw (22).
9. Close the gear covers (21). Attach the
gear covers with the locking screws (20).
Securing the workpiece
Secure with 4-edge lathe
centre (1) and tailstock (5)
1 Draw a diagonal line on both ends of
the workpiece to locate the centre.
The centre is the place where the two
lines meet. Place a centring hole where
the 4-edge lathe and tailstock should
be positioned on the workpiece. This
ensures a better hold.
2. Cut an approx. 2 mm deep saw cut
along the diagonals to give the 4-edge
lathe centre (1) a better grip.
3. Place the removed 4-edge lathe centre
(1) at the centre of the workpiece.
Lightly tap the 4-edge lathe centre (1) into
the workpiece using a mallet (not inclu-
ded in the scope of delivery). Make sure
to protect the thread of the 4-edge lathe
centre (1) e.g. with a wooden board.
4. Remove the 4-edge lathe centre (1)
from the workpiece.
5. Next, (re)attach the 4-edge lathe centre
(1) to the device.
Refer to the section "Installing/
changing the workpiece mounts" for
more on how to assemble and disas-
semble the 4-edge lathe centre.
6. Place the workpiece on the 4-edge la-
the centre (1).
Make sure to meet the notch with the
4-edge lathe centre (1) as otherwise
secure clamping cannot be ensured.
GB IE
23